Back to Search

NTSB investigation record

DEN08CA067

Completed

Diamond Aircraft Industries Da20-c1· N954DA

NTSB Report
Date
March 21, 2008
Location
Pueblo, CO
Conditions
VMC
Record
Published September 25, 2020

Primary finding

Probable cause

the failure of the student pilot, and then the flight instructor to maintain aircraft control during the landing. Contributing factors were the flight instructor's delayed remedial action, and the crosswind conditions.

Investigator assessment

Analysis narrative

Prior to the initial approach, the tower reported the wind was from 280 degrees at 22 knots. During the final approach to runway 26L, the airplane encountered gusty crosswind conditions. Approximately 15 to 20 above ground level with the student pilot at the airplane controls, the airplane nose was 20 degrees to the right and the wings were level. At that time, the flight instructor took over control of the airplane and applied control inputs to correct for the crosswind. The airplane continued to the right and descended "with no response to my inputs." The instructor then applied full power and attempted a go-around. The airplane "lightly" touched down on the runway, however, continued to the right side of the runway surface and contacted rising terrain. Subsequently, the left main landing gear separated and the airplane came to rest upright off the runway.

Source record

Factual narrative

According to the flight instructor and student pilot, they were landing the airplane on runway 26L. Prior to the initial approach, the tower reported the wind was from 280 degrees at 22 knots. During the final approach, the airplane encountered gusty crosswind conditions. Approximately 15 to 20 feet above ground level with the student pilot at the airplane controls, the airplane nose was 20 degrees to the right and the wings were level. At that time, the flight instructor took over control of the airplane and applied control inputs to correct for the crosswind. The airplane continued to the right and descended "with no response to my inputs." The instructor then applied full power and attempted a go-around. The airplane "lightly" touched down on the runway, however, continued to the right side of the runway surface and contacted rising terrain. Subsequently, the left main landing gear separated and the airplane came to rest upright off the runway. The flight instructor and student pilot were not injured. The left wing composite structure was fractured in several areas near the main landing gear attach points. No anomalies were noted with the airframe and engine.

Continue research

Find similar accidents

Continue with the strongest shared characteristics.