ERA12FA303

The pilot's failure to maintain control of the airplane during the aborted landing, which resulted in an aerodynamic stall and impact with terrain.

The pilot receiving instruction performed several takeoffs and landings with a flight instructor aboard. The flight instructor then disembarked and told the pilot to perform three additional solo takeoffs and landings (to a full stop), which the instructor observed from the ground. According to the flight instructor, the pilot's first flight around the airport traffic pattern appeared normal and terminated in a full stop landing and taxi back to the runway for the next takeoff. The instructor stated that the airplane appeared to touch down normally during the second landing; however, shortly thereafter the engine power increased and the airplane began to ascend. The airplane then climbed at a steep angle, entered an aerodynamic stall, and impacted terrain to the left of the runway. Review of data recorded by an onboard recoverable data module showed that as the airplane approached the runway during the landing, the stall warning activated and 1 second later the pilot increased engine power. As the engine power increased, the airplane began an unarrested turn to the left and the pilot retracted the airplane's flaps from the fully extended to the fully retracted position, which was contrary to the airframe manufacturer's published procedure for a balked landing. The data showed that after it reached an altitude of about 75 feet above ground level, the airplane entered an aerodynamic stall, and then rolled left while pitching down. The data recording ended before the airplane impacted terrain. Examination of the wreckage revealed no evidence of preimpact mechanical malfunctions or failures that would have precluded normal operation. The installed whole airframe parachute system likely deployed during the postimpact fire; however, given the low altitude at which the aerodynamic stall occurred, it is unlikely that preimpact deployment of the system would have positively affected the outcome of the accident. Review of the pilot's flight logs showed that he had accumulated more than 330 total hours of flight experience, including more than 220 hours in the accident airplane; however, he had not previously flown the accident airplane solo before the accident flight. Review of autopsy and toxicology test results showed no evidence of any preexisting condition that would have been expected to result in the pilot's incapacitation.

HISTORY OF FLIGHT On April 27, 2012, about 1256 eastern daylight time, a Cirrus Design Corp. SR22, N154CK, was substantially damaged when it impacted terrain shortly after takeoff from Anderson Regional Airport (AND), Anderson, South Carolina. The private pilot/owner was fatally injured. Visual meteorological conditions prevailed, and no flight plan was filed for the flight. The local personal flight was operated under the provisions of Title 14 Code of Federal Regulations Part 91. The pilot's flight instructor, and close friend, recounted the events that transpired prior to and during the accident flight. According to the flight instructor, he had been providing the pilot with flight instruction toward his instrument rating in the weeks preceding the accident flight. The purpose of the flight on the day of the accident was to practice flying under visual flight rules. The flight originated at Greenville Downtown Airport (GMU), Greenville, South Carolina about 1000, and they proceeded to Oconee County Airport (CEU), Clemson, South Carolina, where the pilot performed 1 full stop practice landing, then departed for AND. The flight instructor then monitored the pilot as he performed about 6 or 7 practice takeoffs and landings, all of which terminated in a full stop and taxi back to runway 23. The pilot then taxied the airplane to the fixed base operator (FBO), where the flight instructor disembarked and told the pilot to perform 3 additional practice takeoffs and landings. The pilot's first solo takeoff and landing appeared normal, and after the landing the pilot taxied the airplane back to the beginning of the runway before initiating the takeoff, as he had done previously with the flight instructor aboard. During the second circuit, the flight instructor observed the airplane's landing light on final approach to the runway. The airplane appeared to land normally, touching down within the first 10 to 15 percent of the runway. Expecting the airplane to continue down the runway and exit on a taxiway, he was surprised when he saw the landing light begin to ascend. As it approached, he could see that the airplane had pitched upward steeply, to an angle of about 40 degrees. The airplane climbed in that attitude until the left wing suddenly dropped, similar in appearance to an aerodynamic stall. The airplane then descended in a steep, nose-down attitude until the he lost sight of it behind sloping terrain southeast of runway 23. PERSONNEL INFORMATION The pilot, age 58, held a private pilot certificate with a rating for airplane single-engine land. According to his Federal Aviation Administration (FAA) airman file, the pilot was issued a Notice of Disapproval of Application following unsatisfactory performance of the practical portion of his private pilot certificate practical evaluation on November 14, 2009. The pilot was subsequently re-examined on Area of Operation IV, Tasks D and F (Soft-Field Approach and Landing and Short-Field Approach and Landing), and issued a private pilot certificate on November 28, 2009. The pilot's most recent FAA third-class medical certificate was issued on July 22, 2010, with the limitation "Must have available glasses for near vision." Review of the pilot's personal flight log showed that he began flight training in July 2008. He accumulated 113 total hours of flight experience between that time and the time he earned his private pilot certificate. All but 16 of those hours were completed in Cessna 172 airplanes. In December 2009, the pilot purchased the accident airplane, and since that time, the pilot had accumulated 226 additional hours of flight experience. Additionally, all of the flight experience the pilot had accumulated since that time were logged as either dual flight instruction, or logged with a flight instructor signoff. METEOROLOGICAL INFORMATION The weather conditions reported at AND, at 1256, included clear skies, visibility 10 statute miles, winds from 265 degrees magnetic at 9 knots, temperature 26 degrees Celsius (C), dew point 17 degrees C, and an altimeter setting of 30.02 inches of mercury. The calculated wind components for runway 23 included a headwind of 7 knots and a right crosswind of 5 knots. AIRPORT IN FORMATION The Anderson Regional airport was comprised of intersecting runways configured in a 5/23 and 17/35 orientation. Runway 23 was 6,002 feet long by 149 feet wide, was aligned on a heading of 231 degrees magnetic, and was equipped with a 4-light precision approach path indicator. A parallel taxiway was present on the northwest side of the runway, and the runway intersected runway 17/35 about 3,200 feet beyond the approach threshold. The airport elevation was 782 feet. FLIGHT RECORDERS Recoverable Data Module (RDM) A crash-hardened flight data recording device was installed in the vertical stabilizer of the accident airplane, and was recovered from the airplane at the accident site. The RDM recorded numerous flight parameters at a rate of 1 Hz. Data from the RDM were downloaded without incident, and about 145 hours of flight time were present. The data contained the entirety of the accident flight. All altitudes given below are pressure altitudes recorded by the RDM, unless otherwise stated. The details of the accident flight recorded by the RDM were consistent with the recount of events provided by the flight instructor. As the airplane was on final approach to runway 23, the flaps were fully extended, the airspeed varied between 91 and 99 knots, and the descent rate varied between 1,120 feet per minute and 688 feet per minute. During the final approach, the engine power generally decreased from about 32 percent power to 25 percent as the airplane crossed the runway threshold, at 1255:44. The airplane continued to descend over the next 11 seconds until reaching a low altitude of 742 feet, about 1,700 feet beyond the runway threshold. During that time, the pitch remained relatively stable until 1255:54, when it began to increase, and the stall warning activated 1 second later. At 1255:56, the engine power began increasing and 3 seconds later, the flap position switch transitioned from the down to the up position as the pitch continued to increase to a maximum of 13 degrees nose up. Over the next several seconds, the airplane began turning left and had departed the left lateral boundary of the runway by 1256:01. By 1256:03, the engine power had reached 101 percent, the stall warning remained active, the heading had drifted left from 234 degrees to 208 degrees, the pitch had increased to a maximum of 15 degrees nose up, and the airplane had climbed 75 feet. The final data point was recorded at 1256:05. At that time, the airplane's pressure altitude was 825 feet (about 50 feet above ground level), the heading was 177 degrees, the pitch was 3 degrees nose up, the roll was 57 degrees left wing down, the airspeed was 70 knots, the stall warning was active, the flaps were retracted, and the engine power was at 98 percent. The airplane was 167 feet left of the runway boundary at that point. WRECKAGE AND IMPACT INFORMATION The initial impact point (IIP) was located about 250 feet from the left edge of runway 23, at a point about 2,730 feet from the runway threshold. The IIP was located about 128 feet south of the airplane's final RDM recorded position, on a 180-degree magnetic bearing. The IIP consisted of a 1.5-foot-deep crater that was 7 feet long by 5 feet wide. Located within the crater were two of the three composite propeller blades, which had separated at the propeller hub. An approximate 50-foot wreckage path, oriented about 160 degrees magnetic, led from the initial impact point to the main wreckage. Along the wreckage path were broken pieces of the engine cowling and windscreen. The main wreckage was oriented roughly 330 degrees magnetic, and consisted of the fuselage, wings, and empennage. The fuselage and right wing were almost compl